20
21
Cleaning
Toto Lateral Turning System Platform Cover
Keeping a cleaning record is recommended as the product is suitable for re-use.
Light Soiling
! IMPORTANT
In the absence of gross contamination or unusual risk, the removal of dirt and
spillages with a neutral detergent and warm water should be sufficient. A 0.1% hypochlorite solution
(1,000ppm) may also be used. Ensure that the cover is rinsed with clean water using a single use,
non-abrasive cloth and thoroughly dried. Ensure adequate ventilation.
Heavy Soiling
! IMPORTANT
In cases of gross contamination, the Toto lateral turning system platform cover
should be cleaned first with detergent and water and then with a 0.1% hypochlorite solution
(1,000ppm). Rinse well with clean water and wipe down with a single use, non-abrasive cloth and
thoroughly dry. Ensure adequate ventilation.
! IMPORTANT
If required, a 1% hypochlorite solution (10,000ppm) and cold water may be applied
for no more than two minutes.
Machine Washing Instructions
! IMPORTANT
Disinfection may be achieved by laundering at temperatures not exceeding 65ºC
for 10 minutes or 73ºC for three minutes.
1
1
Protect, Rinse and Dry - BHTA guidance on the care, cleaning and inspection of healthcare
mattresses. (January 2012 - BHTA HM 0112)
Drying
To avoid shrinkage, line dry in a clean, indoor environment. Covers must be thoroughly dried
before re-fitting to the Toto platform.
Do not mangle or iron.
Platform, Cabling, Control Unit and Air Hoses
Before cleaning, disconnect from mains power supply.
The platform, cabling, Control Unit and air hoses can be wiped clean with alcohol wipes and/or a
chlorine derivative. Care should be taken when wiping the Control Unit not to allow liquids to enter
through any apertures.
Cleaning Air Filters
1. Switch off the power supply to the Control Unit.
2. Disconnect the power lead and air hoses.
3. Place the Control Unit on a flat surface with its back panel uppermost (place a soft cloth under
the unit to prevent scratches).
4. Carefully remove the air filter cover located on the back panel of the Control Unit (x1).
5. Remove and clean the filter with clean water and allow to fully dry.
6. Refit the air filter cover to the Control Unit.
7. The Control Unit is now ready for re-use.
