Toto G400 SN920M, Instruction Manual

Page: 29 / 64

29
Top unit
(Approximately daily)
Soft cloth
soaked in water
• Toilet paper
• Dry cloth
• Nylon scrubbing pads
(May cause damage.)
1
Unplug the power plug.
2
Wipe with a soft cloth that
has been soaked in water
and wrung-out thoroughly.
■ For heavy dirt

Wipe with a soft cloth soaked in diluted,
neutral kitchen detergent, and then wipe
with a soft cloth soaked in water.
• Neutral kitchen
detergent
• Paint thinner
• Benzene
• Powdered cleanser
3
Insert the power plug.

The POWER LED lights up.
Attention!
● The Washlet is an electric appliance.
Be careful not to let water seep inside or leave detergent
in the gap between the top unit and bowl unit.
(May damage plastic parts or cause a malfunction.)
●
When using a toilet cleaner to clean the
toilet, wash it off within 3 minutes and leave
the toilet seat and toilet lid open.
  Wipe off any cleaner that remains on the bowl
unit. (If vapor from a toilet cleaner enters the
top unit, it may cause a malfunction.)
●
Do not push or pull the covers around the
wand with undue force.
(May cause damage or malfunction.)
●
Wipe the back surface of the toilet seat and
the toilet seat cushions with a soft cloth
tightly wrung out with water.
(Otherwise adhesion of dirt may result in discoloration.)
2
Bowl Unit
(Approximately daily)
• Toilet brush
• Neutral toilet
detergent
• Strongly acidic cleaners or strong
alkaline cleaners
• Cleaners containing abrasive compounds
• Fluoride-based detergent
(containing hydrogen fl uoride or
ammonium fl uoride)
• Wire brush
• Abrasive nylon scrubbing brush
1
Unplug the power plug.
2
Clean with a toilet brush or a
similar tool.
■ If the bowl unit is clogged

Using plunger or similar, provide 10 cm
(0.33 ft) or more clearance between the top
of the bowl unit and the water surface.
Use commercially available tools that are
made for unclogging the bowl unit.
(May cause over
fl ow of dirty water and water
damage.)
Vinyl sheet,
etc.
Keep 10 cm
(0.33 ft) or more
■ If the fl oor is dirty

Clean it with a well wrung cloth. (Not cleaning
the
fl oor may cause stains or corrosion.)

Sitting is recommended to reduce splashing
caused by standing and urinating.
3
Insert the power plug.

The POWER LED lights up.
Attention!
●
Do not use any water repellant, stain-proo fi ng
cleaner, surface coating agent, or on-tank/in-
tank toilet cleaner.
These products would not damage the porcelain surface,
but they may cover the porcelain surface and reduce the
effect of the built-in stain prevention technology.
Maintenance