Toto CST604 Series, Installation Manual

Page: 3 / 28

3
ENGLISH
BEFORE INSTALLATION
Supply Valve
Wall
12"
C/L
Closet
Flange
C/L
6" *
* Recommended
minimum
requirement.
INSTALLATION PROCEDURE
Ill. 1
Ill. 2
1) Clean any debris out of the closet flange, then install the
mounting bolts into the slots of the flange (see Illustration 1). The
bolt should be inserted into the slot with its head down and
threaded shank pointed upward.
2) Carefully turn the toilet upside down on some padding. Firmly
press a new wax seal (not supplied) onto the circular recess
around the outlet opening (see Ill. 2). Turn the toilet upright and
gently lower it into position over closet flange & bolts. With the
toilet properly aligned, press down firmly on both sides of toilet
rim to seat wax seal.
CAUTION: Do not move toilet after the wax seal is set.
3) Insert the cap base, washer and thread nuts onto the bolts and
hand tighten. Then tighten the bolts an additional ½ turn. Install
the bolt caps.
NOTE: check that cap does not fit properly, check that cap base
has the correct side up indicated by THIS END UP (THIS PART
UP). Or check for interference of the mounting bolt with the cap.
Carefully cut the bolt length to allow the cap to fit.
WARNING! Do not over-tighten the nuts. Damage to china or
plastic parts may result.
In order for your new TOTO toilet to fit correctly,
check the dimensions below:
Double Combination WYE / 1/8 Bend
YES
Double Sanitary Tee / Sanitary Cross
NO
Due to the powerful performance of our Cyclone, G-Max,
E-Max and Power Gravity flushing systems, they are not
specified for back-to-back installations. The only means of
installing these toilets in a back-to-back situation is when the
toilet drain connections incorporate a WYE fitting. Please
contact your builder or contractor prior to this installation.
IMPORTANT!
Read these instructions thoroughly before beginning
work. Please leave instructions for customers.
These instruction contain maintenance and warranty
information.
If necessary, remove the existing toilet.