8
Safety Precautions
(Continued)
CAUTION
Do not fold or crush the water supply hose; do not damage by cutting with a
sharp object.
x
Doing so may cause water leaks.
Do not install the base plate, which is not attached.
x
Doing so may cause damage.
If a water leak should occur, always close the shutoff valve.
When the ambient temperature is likely to drop to 0°C or lower, prevent
damage to the pipes and hoses due to freezing.
x
Frozen water pipes could cause the main unit and the pipes to break, resulting in a water leak.
x
Regulate the room temperature to prevent the pipes and hoses from freezing during cold months.
x
Drain the water.
When not using the product for a long time, close the shutoff valve, drain
the water from the main unit and water supply hose, and then turn off the
breaker on the distribution board.
x
When using the product again, allow the product to re
ll with water
rst. Otherwise, the water in
the tank might become contaminated and cause skin in
ammation or other problems.
(Refer to Page 58 for instructions on replenishing the water.)
x
Leaving the power on may cause
re or heat.
When installing the water
lter drain valve, make sure that it is securely
tightened in its proper position.
x
Failure to securely tighten it may cause a water leak.
If the bowl unit is clogged, switch the breaker on the distribution board to
OFF and remove the clog.*
1
x
If the auto
ush were allowed to function, it would make the wastewater in the bowl unit over
ow
and may result in water damage.
x
Use commercially available tools that are made for unclogging the bowl unit to remove the clogging.
Push the main unit securely on to the base plate.
x
After pushing the main unit until a click sound is heard, pull it slightly toward you to make sure
that the product does not detach.
x
Failure to do so could cause the main unit to come loose and fall resulting in injury.
Make sure of the plus and minus signs on the batteries before inserting them.
Remove depleted batteries immediately.
When replacing the batteries:
Replace both batteries with new ones.
Use the same brand for both new batteries (any brand available).
x
Failure to do so may cause the batteries to leak
uid, generate heat, rupture, or ignite.
When the product is supposed not to be used for long time, remove the
batteries from the remote control.
x
Failure to do so may cause the batteries to leak
uid.
*1 Available only when "FLUSH" button is located on the top side of the remote control.
