Settings
The “Settings” sreenshots
C.
Start
TOTEM units work based on the “thermal
automatically
load is present
TOTEM unit.
In addition to fulfillin
by the User by operating
Once start is
under the following
The temperature value can be set in
in the range from
In addition to the start temperature
set. When the temperature of water
unit automatically
The unit is also
the pump start command
commanded to stop with a delay that can be set by the user. The delay is
let water circulate
User’s Guide | TOTEM 10
The “Settings” sreenshots allows to set some of the unit’s operating parameters
Start temperature
Stop temperature
External pump stop delay
Starting and Working Principle
units work based on the “thermal priority” principle, that
automatically switch to simultaneous delivery of heat and electricity
present that allows to recover heat from the internal recovery
unit.
In addition to fulfilling the aforementioned condition, the unit’s Start must
by the User by operating the “ON” button that is found on the Operator panel.
Once start is enabled, the TOTEM starts functioning following a demand
under the following conditions:
Activation of the User’s Water system circulator pum
the unit’s on-board flow switch;
Water temperature below the value set by the User.
emperature value can be set in the “Settings” screenshot on the Operator Panel
in the range from 30 to 70°C.
In addition to the start temperature value, the stop temperature
set. When the temperature of water from the supply line exceeds the set value, the
automatically stops, going into stand-by mode.
also fitted with an external pump control outlet. When the st
the pump start command is also enabled. When the unit stops,
commanded to stop with a delay that can be set by the user. The delay is
let water circulate within the unit after it is switched off thus allowing
User’s Guide | TOTEM 10 - TOTEM 20
23 of 30
allows to set some of the unit’s operating parameters
that is to say, they
delivery of heat and electricity whenever a heat
recovery system of the
, the unit’s Start must be enabled
the Operator panel.
lowing a demand for heat
pump, as detected by
Water temperature below the value set by the User.
s” screenshot on the Operator Panel
, the stop temperature value will also be
exceeds the set value, the
pump control outlet. When the start is enabled
stops, the pump is also
commanded to stop with a delay that can be set by the user. The delay is needed to
allowing it to cool down.
