8
9
Using your Tornado II Slim
Atomizer Head Replacement
Airflow adjustment: Airflow resistance can
be adjusted for personal taste. Turn the airflow
adjustment ring clockwise to tighten the draw, and
anticlockwise to loosen.
Atomizer protection: During operation, if the button is
held down for longer than 15 seconds the button light
will flash 10 times and the battery will stop powering
the atomizer.
Atomizer resistance detection: If atomizer resistance
lower than 0.3 ohms is detected the button light will
flash 5 times quickly when the button is pressed,
indicating short circuit or an atomizer fault. If atomizer
resistance greater than 5 ohms is detected, the button
light will continuously flash slowly, indicating open
circuit, no atomizer fitted, or an atomizer fault.
Invert the Tornado II Slim and unscrew the battery and
atomizer base from the tank. Unscrew the atomizer
head and remove from the atomizer base. Screw the
new atomizer head into the atomizer base and firmly
tighten. Refit the atomizer base into the tank. Connect
the assembled tank to the battery and the Tornado II
Slim is ready to use.
