TOTALINE CPE230RF, Owner'S Manual

Page: 10 / 16

11. The Copy command can be used to copy the previous day’s schedule if
the schedules are the same. The copy command becomes available after
all the occupied periods are programmed in a day. Use the UP ARROW
to change the copy command to YES. Use the DOWN ARROW to change
the copy command to NO. Press the Mode/Next button when the choice
has been made. See Fig. 6.
If NO was selected, the schedule will automatically change to the next
day and the user must enter the occupied and unoccupied schedules for
that day.
NOTE: Occupied 1 schedule heating and cooling set points are the same
for each day. Occupied 2 and 3 set points may be set to different values
for each day of the week.
If YES was selected, the schedule will be copied to the next day. The
schedule copy may be repeated until Sunday is reached. The Sunday sched-
ule cannot be copied to Monday.
12. After all the times and set points for each day have been entered, press
the Program button to finish entering the schedule.
NOTE: The thermostat will continue to follow the schedule until a new one
is entered.
• If only one occupied schedule is selected, the Occupied 2 and 3 schedules
are skipped.
• If the start time is set later in the day than the stop time, the program will
run from midnight of that day to the stop time and then from the start time
to midnight.
• If the same start and stop times are programmed for an occupancy sched-
ule, the thermostat will be in Occupied mode for 24 hours.
• If one occupied period starts or stops within another occupied period, the
lower numbered schedule has priority. For example, if schedule
Occupied 3 is running for 24 hours and occupied schedule 2 comes on
from 1 to 3 PM, the set points from Occupied 2 are in effect from 1
to 3 PM.
OVERRIDING THE SCHEDULE — The schedule can be overridden during
operation by pressing the UP or DOWN ARROW buttons to change the de-
sired temperature. The thermostat will use the new set point until the next
scheduled time period starts.
10