Total TIDLI200215, Manual

Page: 13 / 16

13
Keep one hand on the grip and the other hand on the bottom of the battery cartridge to
control the twisting action.
Screwing operation
Caution
Set the adjusting thread to the proper torque level for your job.
Make sure the bit is inserted straight into the screw head, or the screw and/or bit may be
damaged.
•
Place the tip of the bit on the screw head and apply pressure to the tool.
•
Start the tool slowly and then gradually increase the speed.
• Release the switch trigger as soon as the clutch engages.
Note: When driving a wood screw, pre-drill a pilot hole 2/3 the diameter of the screw. Makes
driving easier and prevents the workpiece from splitting
.
Hammer drilling operation
Caution
A large and sudden twisting force is exerted on the tool/bit at the time of hole penetration,
when the hole becomes clogged with chips and particles, or when hitting rebar
embedded in concrete.
•
First, turn the action mode change screw so that the arrow on the tool body points
to the mark. The adjusting thread can be aligned at any torque level for this
operation.
• Be sure to use a tungsten carbide tipped drill bit. Position the bit at the desired
hole location, then pull the switch trigger. Do not force the tool. Light pressure
gives best results.
Keep the tool in position and prevent it from slipping out of the hole. Do not apply more
pressure when the hole is clogged with chips or particles.
Instead, run the tool at idle speed, then remove the bit partially from the hole. Repeating
this several times will clear the hole and normal drilling can resume.