12
The tightening torque can be adjusted in 18 steps by turning the adjusting ring. You can
get the minimum tightening torque at 1 and the maximum torque at 18.
•
Align the graduations with the arrow on the tool body.
•
Before actual operation, drive a test screw into your material or a piece of
duplicate material to determine what level of torque is required for a particular
application.
Mounting
Attention
Always make sure the tool is switched off and the battery cartridge is removed before
carrying out any work on the tool.
Bit installation or removal
1. Chuck
2. Close
3. ablaugh
•
Turn the ring counterclockwise to open the chuck jaws.
•
Put the bit into the chuck as far as it will go.
•
Turn the ring clockwise to tighten the chuck.
•
To remove the bit, turn the thread counterclockwise.
The hook is convenient for temporarily hanging the tool. This can be installed on either
side of the tool. To install the hook:
•
Insert it into a slot in the tool housing on each side
•
Secure it with a screw.
•
To remove it, loosen the screw and then pull it out.
Start up
Attention
Always insert the battery cartridge all the way in until it clicks into place. If you can see
the red part at the top of the button, it is not completely locked.
Insert it fully until the red part is no longer visible. Otherwise, it may accidentally fall off
the tool and injure you or someone around you.
Summary of Contents for TIDLI200215
Page 1: ...1 vV BATTERY HAMMER DRILL TIDLI200215...
Page 15: ...15 Exploded view...
Page 16: ...16 BATTERY HAMMER DRILL...
