Total TIDLI200215, Manual

Page: 10 / 16

10
•
When the direction change switch lever is in the neutral position, the switch
trigger cannot be pulled.
Attention
Always check the direction of rotation before operation.
Use the reverse switch only after the tool has come to a complete stop. Changing the
direction of rotation before the tool stops can damage the tool.
When not operating the tool, always place the reversing switch lever in the neutral
position.
Fast change
1. Gear shift lever
Gear shift switch
position
Speed torque Operation
1 Under High
heavy load
operation
two High Under light load operation
•
To change the speed, turn off the tool.
•
Select side "2" for high speed
• Select "1" for low speed but high torque.
Note: Make sure the gear shift lever is in the correct position before operation.
If the tool speed is extremely low during operation with "2", slide the lever to "1" and
restart the operation.
Attention
Always put the gear shift lever fully in the correct position. If you use the tool with the
speed change lever positioned midway between side "1" and side "2", the tool may be
damaged.
Do not use the speed change lever while the tool is running. The tool may be damaged.
Select the mode of action
Attention
Always set the thread correctly at the mark you want. If you operate the tool with the
thread positioned midway between the mode marks, the tool may be damaged.