Total TG111165, Manual

Page: 9 / 11

9
Working tips for your drill
1) Masonry and concrete drilling:
a. Place the drill/impact action selector switch in the "hammer symbol"
position.
2) drill steel
a. Place the drill/impact action selector switch in the "drill symbol" (drill)
position. HSS bits should always be used for drilling steel at a lower
speed.
3) Screw
a. Place the drill/impact action selector switch in the "drill symbol" position.
Use low speed to insert or remove screws.
4) pilot holes
a. When drilling a large hole in a strong material (eg steel), we recommend
drilling a small pilot hole first before using a large drill bit.
5) drilling tiles
a. Place the drill/impact selector switch in the "drill symbol" position to drill.
When the tile has been penetrated, switch to the "hammer symbol"
position.
6) cool the engine
a. If your power tool gets too hot, set the speed to maximum and run with no
load for 2-3 minutes to cool down the motor.
Maintenance and troubleshooting
Before doing any maintenance and cleaning work on the machine, unplug the power
cord from the socket.
Maintenance
•
Your power tool requires no additional lubrication or maintenance.
• Never use water or chemical cleaners to clean your power tool. Clean with a dry
towel.
• Get your parts repaired at an official dealer.
•
Always store your power tool in a dry place.
•
Keep the motor ventilation slots clean.
• If you see a few small sparks in the ventilation slots, this is normal and will not
harm your power tool.
• If the power cord is damaged, it must be replaced.
Problem solving
•
If your drill doesn't work, check the power at the mains socket.
•
If the drill is not working properly, check the bit for sharpness, replace the bit if it
is worn. Check that the drill is set to rotate forward for normal use.
•
If you still have problems, contact your official dealer.