ASSEMBLY INSTRUCTIONS - TOTAL GYM 26000
ASSEMBLE THE LADDER.
LADDER STRUT—Lower
Place the ladder base on the floor with the non-skid surface down. Align the holes in the uncapped
end of the ladder struts with the inside of the rear holes in the base. As you prepare to secure the
bottom of the ladder struts to the base with two of the 3/8"-16 X 2 3/4" hex head bolts, set the
capped end of the ladder struts slanted toward the open end of the base. Place a 3/8" washer
on a 3/8"-16 X 2 3/4" hex head bolt. Insert the bolt through the ladder base and ladder strut.
Place another 3/8” washer onto the the exposed end of the bolt. Attach a 3/8" nut and tighten
with a wrench.
LADDER STRUT—Upper
Align the bottom holes in the ladder with the forward holes in the ladder base. Join them together
using the 3/8"-16 X 3" hex head bolts, 3/8" washers and 3/8" hex head nuts. Align the top holes
of the ladder struts with the holes in the middle of the ladder. Secure the ladder struts to the ladder
with the two remaining 3/8"-16 X 2 3/4" hex head bolts, 3/8" washers and 3/8" hex head nuts.
RAIL TO LADDER ASSEMBLY
Carefully open the rail assembly and lay it flat. Raise the assembly (curved end) up in front of the
ladder and attach it to the ladder at mid-level by placing the rubber protected rings over the level
adjustment hooks.
PLYO-STRUT ASSEMBLY
Locate the outer plyo-strut tube with the locking handle attached. Slide the outer plyo-strut tube
onto the inner plyo-strut tube, which is welded to the center of the rail assembly.
Attach the outer plyo-strut tube to the ladder base crossbar, by aligning the outer plyo-strut tube
between the ladder base crossbar tabs. Secure it with the supplied detent pin. Then, snugly secure
the plyo-support locking handle. It is not necessary to crank it tightly. Note: The plyo-support
locking handle must be loosened to change levels. Tighten it after changing levels and during
plyometric exercises.
5
TOTAL GYM 26000 OWNER’S GUIDE
OWNER’S GUIDE
TOT
AL
GYM 26000
800 541 4900 EFISPOR
TSMEDICINE.COM
5
outer plyo-support tube
inner plyo-support tube
3/8"-16 X 2 3/4"
Hex head bolt
3/8"-16 X 2 3/4"
Hex head bolt
3/8"-16 X 2 3/4"
Hex head bolt
3/8"-16 X 2 3/4"
Hex head bolt
3/8"-16 X 3"
Hex head bolt
3/8"-16 X 3"
Hex head bolt