9
TOTAL GYM
®
JUMP TRAINER
TM
OWNER’S GUIDE |
ASSEMBLY & INSTALLATION
TOTAL GYM
®
JUMP TRAINER
TM
OWNER’S GUIDE |
ASSEMBLY & INSTALLATION
ASSEMBL
Y & INST
ALL
STEP 6. FITNESS ASSEMBLY
FOR PHYSICAL THERAPY ASSEMBLY GO
BACK TO STEP 5
Using hardware (R), as indicated, first
insert plastic plugs into hole 1 on the
inside and outside of each Strut (as
shown below).
Hole 1
These holes
come already
plugged - do
not remove
Hole 1
Next, attach Front Base to holes 2, 3 and
4 as shown below using hardware (H,K,J)
as indicated. Make sure to install the
washer (K) on the bolt first (H). After all the
bolts and nuts are installed, tighten them
completely. Then cover each with a plastic
cap (M).
J
H,K
Hole 1 plugged
in Fitness Setting
Hole 2
Hole 3
Hole 4
The image below is how the Front Base
attached to the Struts should look for the
FITNESS Setting.
Front Base Does
not attach to Hole 1
in FITNESS Setting
STEP 7.
FITNESS ASSEMBLY
FOR PHYSICAL THERAPY SETTING SKIP
TO STEP 8
Adjust Rear Struts / Incline Strut for
FITNESS Setting.
NOTE:
The Rear Strut / Incline Strut
comes factory assembled in the PHYSICAL
THERAPY Setting. Only do this step if you
want your Jump Trainer assembled for the
FITNESS Setting.
PHYSICAL THERAPY Setting
7A.
Remove the two caps and four plugs.
Remove a nut from the axle with the two
wrenches. Pull axle out completely.
7B.
Gently push out struts to prevent
scratching paint as you slide Incline Strut
up to the FITNESS hole.
FITNESS hole
Incline Strut
Struts
7C.
Reinstall the axle and nut with the two
wrenches and tighten completely; then
press on the two caps and four plugs.
The Incline Strut is now installed on Rear
Struts for FITNESS Setting.
FITNESS Setting
FITNESS
ASSEMBLY
