44
Note:
All wiring must comply with local and national electrical codes and
must be installed by a licensed electrician.
Test Run
Only perform test run after you have completed the following steps
• Electrical Safety Check – Confirm that the unit’s electrical system is safe and
operating properly
• Gas Leak Check – Check all flare nut connections and confirm that the system
is not leaking
• Confirm that gas and liquid (high and low pressure) valves are fully open
2. Check for Electrical Leakage
During the Test Run, use an electroprobe and multimeter to perform a
comprehensive electrical leakage test.
If electrical leakage is detected, turn off the unit immediately and call a licensed
electrician to find and resolve the cause of the leakage.
Note:
This may not be required for some locations in the US.
