P . 14
Limit Setting
■
Limit Setting (instructive operation)
❶
Switch the Motor Set ON.
❷
Press the OPEN or CLOSE button of remote
controller or button switch.
❸
Pilot Roller will move in the full-closing direction and
stop after reaching the full-closing position.
❹
After stopping at the full-closing position, Pilot
Roller automatically moves in the full-opening
direction and stops at the full-opening position,
thereby completing the instruction.
Caution
Please always start the instruction with the curtain hanging condition.
Be sure to run the instruction sequence with the motor set installed on the Rail
Set.Note that Pilot Runner will move at the slowest speed while executing the
command. This does not indicate an error or a defect.
Please don’t move curtains for 5 seconds after the instruction.
If the process is interrupted in this way, issue the command once again. Note that
the system will not recall the Limit Position if power is interrupted or the process is
otherwise aborted while the command is being executed. (Once this command is
completed, the Limit Position will be recalled even if power is interrupted.)
●
When powered on, the system executes an instruction that automatically detects the full
opening/closing position (Limit Position) of the curtain. Always confirm that this instruction
is performed before use.
❷
Press button
❹
After the full-opening
operation, setting is finished.
❶
Switch ON.
❸
The full-closing
operation
P . 15
❶
Change the Address Setting Switch to "F" (refer
to "Setting Method of the various switches"
described on page 11).
❷
Unplug the product.
❸
Wait for at least 5 seconds after unplugging,
then plug the power cord in again and power
on the product. Limit settings have been
reset.
❹
Set the Address Setting Switch again to a
preferred number (1–9).
■
An initialization of Limit Setting
●
The Limit Position can be set to assume a new value when curtains are replaced or in the
event of another action.
❶
Press and hold the STOP button for 5 seconds to
switch to intermediate limit setting mode.
❷
Press and hold the OPEN or CLOSE button until
the curtains reach the desired limit position.
❸
If moving in the OPEN direction, press the
STOP button 3 times and the OPEN button 1
time to set the intermediate limit position. If
moving in the CLOSE direction, press the stop
button 3 times and the CLOSE button 1 time to
set the intermediate limit position.
❹
Press the STOP button 5 times to end
intermediate limit setting mode.
■
Intermediate Limit Setting
●
Intermediate limits can be set for both the opening and closing directions. These can be set
with the 3 button switch or infrared remote control; they cannot be set with the FM
remote-control transmitter.
OPEN: press and
hold for 5 sec.
×3
×5
×1
×1
Press and hold until curtains
reach the desired limit
position
or
or
* Turn switch 1 of Function Setting of DIP Switch to OFF.
❶
❶
❷
❷
❸
❸
❹
❹
