■
Function Setting of DIP Switch
●
The control switches are used to set the functions for various operating switches.
●
When shipped, all switches are set by default to their OFF positions.
Switch 1
Switch 2
Switch 3
Switch 4
Functions to be set
The setting operations of Two-button and three-button
The setting operation of self hold circuit on Two-button
Enables/disables Touch-motion functions
Switches motor rotation direction
ON
Two-button
Function to be set
Enable
Reverse
OFF
Three-button
Function to be not set
Disable
Normal
●
Touch-Motion Function enables opening/clos-
ing of curtains without using any switch
operations.
●
By pulling the curtain (Pilot Runner will move
5cm), the curtain will move (motor will operate in
the corresponding direction) and stop at Limit
Position.
* Switch 1 :ON Switch 2: OFF setting (two button
operations/ no function) will disable Touch-
Motion function. Apply a different setting.
<The Touch-Motion Function>
●
This function enables switching of motor rotation direction without reassembling the Rail
Set. Use this if the Rail Set has been accidentally assembled in the reverse orientation.
●
Turn Switch 4 ON, unplug the power cord, wait for at least 5 seconds, then plug the power
cord in again.
●
When you power on the product, the motor will rotate in the opposite (reverse) direction.
●
Press the OPEN or CLOSE button to initiate instructive operation.
*
For detailed information on instructive operation, refer to "Limit Setting Method" described
on page 14.
<Rotation Direction Selecting>
Caution
Always operate with the switch when you want to stop the curtain track. Forcibly
pulling the curtain will cause damage.
P . 12
Approx.5cm
Moves
P . 13
OPEN: press and hold for 3 sec.
OPEN
Speed Setting:5
OPEN
Accelerates toward
speed A
■
Speed Setting Switch (sec./m)
●
Switch for changing the opening/closing speed for the curtain.
●
The speed setting switch are set by level “5” when the unit is delivered.
(* speed changes
by the weight of curtain.)
■
Address Setting Switch
●
Switch for setting the address for infrared remote control (9ch).
●
When using infrared remote control (9ch), set within the range of 1 to 9.
●
The address setting switch are set by level “1” when the unit is delivered.
*
In case of FM remote control 2.4G,please refer to "Instruction Manual'' of FM Receiver 2.4G
and set the address.
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
9
9
A〜F・0
̶
Speed level
Speed (sec./m)
Address Setting Switch
Channel
1
11
2
10.5
3
10
4
9
5
8.5
6
8
7
7
8
6
9
5.5
A〜F
4.5
●
This function is available only with 3 button switch.
●
Press and hold the OPEN or CLOSE button for 3 seconds to accelerate opening/closing
speed from set speed to the maximum speed (4.5 sec./m).
●
Press switch in the same direction again to moving cancel accelerate mode and back to
set speed.
<Acceleration Mode
〉
