13
3
Set the installation angle of the TV set
(1) When it is set vertical (0°)
●
No angle adjustment is needed
●
Loose the fixed strewing
B
by following the step of
2
-
①
.
●
Make sure both of the fixed screwing
A
and
C
are
fastened.
Fixed screws
Fixed screws
Fixed screws
Fixed screws
Fixed screws
Fixed screws
(2) When setting the angle
●
Angle can be set to 5°, 10°, 15°.
●
Put down the angle adjustment part of the wall bracket, match with the hole at the front side to the selected angle
setting hole in the wall bracket and install the fixed screw
B
disassembled in step
2
-
①
.
●
Install the wall brackets at the both sides by same method
※
Please make sure that the installation angle of the TV shall keep correspondence with the installed spacer.
The lower part of the TV back will press against to the wall if the spacer is improperly used.
0
15
10
5
You do not use it
At 15°
At 10°
At 5°
State of side metal brackets on the wall after angle adjustment
Angle adjustment
Fixed screws
Fixed screws
Angle adjustment
part
(3) Installation of "long fixing screws (M5×160) for TV set"
●
Use "long fixed screws(M5×160) for TV set" from the supplied bag
Ⓕ
for temporary fixing and keep a distance of
about 10 mm to the "wall bracket".
With width of
about 10mm
Fixed length screws
for TV set (M5×160)
In vertical (0° ) position
Position with angle set
C100047_WAL14C_EN.indd 13
2010/12/15 13:34:13
