TRANSPORTATION AND INSTALLATION MANUAL
STE80753
– 37 –
c)
When the controller is mounted on the rack, the weight of the controller should be
supported with the legs of the controller. Screw holes for rack-mounting the
controller are used for securing the controller panel, and the weight of the
controller cannot be supported only with these screws.
d)
On the front of the controller, a clearance of approx. 90 mm should be provided
for connecting the connector of the teach pendant. Even if the teach pendant is
not used, a clearance of approx. 60 mm is required for connecting a dummy plug.
Fig. 3.13 Clearance of controller front side
3.4
Precautions for Handling the Teach Pendant
Be careful of the following matters when handling the teach pendant.
!
CAUTION
• DO NOT drop the teach pendant or hit it against anything.
• DO NOT pull the cable running from the teach pendant.
• DO NOT press the switches on the teach pendant with anything sharp (like
the tip of a knife, pencil, ball-point pen, etc.).
• DO NOT place or use the teach pendant near open flames.
• DO NOT leave the teach pendant in direct sunlight for a long period of time.
