Toshiba TEC EO1-32003, Owner'S Manual

Page: 92 / 96

16. CLEANING THE PRIT HEAD
16. CLEANING THE PRINT HEAD
16- 1
16. CLEANING THE PRINT HEAD
If the print head is dirty, printing will not be clear. The print head should be cleared with a print head
cleaner everyday before use, according to the following procedure:
1. Open the printer cover and turn the head-up lever to the anticlock wise. (See page 8-1)
2. Clean the print head element with the print head cleaner.
NOTE: Be careful not to damage the print head when cleaning.
3. If any label paste is found on the label cutter, wipe off the paste with alcohol.
■
After removing the label cutter, reattach it using the following procedure.
1. Remove the receipt/label from the scale.
2. Install the label cutter, aligning the cutter notches with the screw holes.
3. Secure the cutter with the screws (B-3x6) so the bottom of the cutter is 0.5 to 0.8 mm above
the peel-off plate.
NOTES:
1. If the cutter is scratching labels during printing, increase the clearance between the cutter and the
peel-off plate.
2. When the cutter is stained with glue or paper dust, clean it with a cotton swab moistened with
alcohol.
Print Head Cleaner
Screw (B-3x6)
Label Cutter
Label Cutter
Strip Plate
Clearance
0.5
〜
0.8 mm
Screw (B-3x6)
Print Head Element
Care must be taken not to injure your fingers with the receipt cutter during installing, removing
or cleaning it.
WARNING!