APPENDIX 1 SPECIFICATIONS
EO1-33029
A1.3 Media
A1- 3
A1.3.1 Media Type (Cont.)
[Unit: mm]
Label dispensing mode
Item
Batch mode
Cut mode
Label: 38.0
c
Minimum media pitch
15.0
Tag: 25.4
d
Label length
Min. 12.5
Min. 32.0
e
Width including backing paper
100.0- 242.0
100.0 – 235.0
f
Gap length
2.5 – 20.0
6.0 – 20.0
g
Black mark length (Tag paper)
2.0 – 10.0
h
Effective print width
216.8
±
0.2
i
Print speed up/slow down area
1.0
j
Black mark length (Label)
Refer to NOTE 3 below.
Max. print length
640.0
Maximum effective length for on the fly issue
320.0
Max. outer roll diameter
φ
230
Label + backing paper
0.13 – 0.18
Thickness
Tag
0.08 – 0.18
A1.3.2 Detection Area of the Transmissive Sensor
The transmissive sensor is movable from the center to the left edge of media.
The transmissive sensor detects a gap between labels, as illustrated below.
NOTES:
1. To ensure print quality and print head life use only TOSHIBA TEC specified media.
2. When using the cutter ensure that label length
d
plus inter-label gap length
f
exceeds 38 mm.
(i.e. label pitch should be greater than 38 mm.)
3. When requesting black marks on label rolls, the following requirements must be satisfied.
When the gap length is less than 4 mm:
The black mark length should be longer than the gap length.
When the gap length is 4 mm or more:
The black mark should not overlap the gap for more than 4 mm or the following label.
4. “On the fly issue” means that the printer can feed and print without stopping between labels.
Sensor position
Area to be detected.
Center of media
Print side
Min. 12 mm
Label
Gap
Label
Min. 2.0 mm
(Min. 6.0 mm when using
the cutter module.)
Sensor is movable
within this range.
Media feed direction
Summary of Contents for TEC B-852-TS12-QQ
Page 1: ...TEC Label Tag Printer B 852 TS12 QQ Owner s Manual ...
Page 116: ......
Page 117: ......
Page 118: ...E PRINTED IN JAPAN EO1 33029A ...