Toshiba TDP-TW355, Owner'S Manual

Page: 28 / 48

53
Operations
52
Setting up the wireless LAN (Continued)
■
Setup using the Setting display (2)
●
Projector settings (Be sure to read this subsection.)
Using the factory settings as-is may suffer security damage, so be sure to
change the projector settings.
1. Press the MENU button twice
2. Select a Category
3. Make settings
Select a category by using
.
The following three categories
are available:
Displays the current settings
of selected category.
Item shown with gray cannot
be set with the currently
selected input source.
p.54
Wireless utility
setup
p.60 Slide Show setup
Status display p.65
The figure shows a typical example. As the display
may differ depending on the item, use the following
pages as a reference.
Item
The Setting display (2) is displayed.
* Appears only when Wireless/Card or USB memory input.
These marks signify the items can be
selected from the list by using .
After an item is selected, apply it by
pressing .
Press or to open the menu.
4. Back RETURN button
5. End Press the MENU button or RETURN button.
(The menu disappears 30 seconds after the last operation.)
■
Caution when using the wireless LAN functions
The Wireless LAN in this unit uses the 2.4 GHz waveband. If there is a similar wireless
LAN in the area, or a wireless device using the 2.4 GHz waveband, or a microwave
oven, the communication efficiency of this apparatus will be reduced, and may become
unusable, but it is not a fault. If this happens, check an area away from the current
location that will not cause radio interference to medical, industrial and public equip-
ment, and change to it, or stop using the unit.
Note
• When the item (2) of the Setting display menu is set or when the setting window
disappears after the settings are changed, the message “Saving...” appears on the
screen. Be sure not to turn the projector power off or unplug the power cord in such a
case.