Toshiba TDP-P7, Owner'S Manual

Page: 19 / 69

E-8
Preparing the Remote Control
Inserting the Batteries
Install the supplied batteries to use the remote control.
2
Insert the batteries to match
the "+" and "–" as indicated in-
side the compartment.
1
Slide the battery compartment
cover (located on the bottom of
the remote control) and pull off.
(B)
(C)
(A)
3
(A) Leaving a little space in the front,
close the lid, (B) then with the back
pressed tightly, (C) press the lid towards
the front.
CAUTION
Dispose of batteries in a designated disposal area. Do not throw batteries into a fire. Attention should be drawn to the
environmental aspects of battery disposal. Do not mix battery types or combine used batteries with new-ones.
Note
* If the remote control does not operate correctly, or if the operating range becomes reduced, replace both batteries with new ones.
* If the batteries are dead or if you will not use the remote control for a long time, remove the batteries to prevent battery acid from leaking
into the battery compartment.
Remote Control Range
Point the infrared transmitter of the remote control toward the remote control sensor located at the front or rear of the main unit
and operate.
Reception of the remote control signal should generally be possible within the range illustrated below.
30
°
50
°
50
°
4m/13.1 feet
3m/9.8 feet
7m/23.0 feet
7m/23.0 feet
6m/19.7 feet
4m/13.1 feet
20
°
20
°
30
°
Side View
Top View
Remote con-
trol infrared
transmitter
Remote control sensor
Remote control
sensor
Remote control in-
frared transmitter
Note
* Exposure of the main unit's remote control sensor or the remote control infrared transmitter to bright light or the obstruction of the signal
by an obstacle located in the pathway may prevent operation.
* The remote control will not function when the battery is exhausted.