RD022-RGUIDE-01-E
2019-Jan-15
Rev.1.0
29
/
31
© 2019
Toshiba Electronic Devices & Storage Corporation
Auto Lead Angle Setting
For high efficiency, TB6605FTG needs to be set a lead angle parameter.
When you use a different motor, change a lead angle parameter if necessary.
And also change the TCR parameter for good lead angle value.
Figure 8-5 Auto Lead Angle Setting
Usage Notes
‒
To ensure that power supply is at the range of 10V to 28V, and current is under 2A (limited by
Motor spec).
‒
At high current working states, motor and control board may have a high temperature.
‒
Some of the unused pins of the product have not been processed in any way.
Make sure to process these pins as appropriate for your system.
‒
Resistors and capacitors in pin sockets can be changed if necessary when other than the
attached motor is used.
Resistor value can be
changed
