11
Preparation
SETTING UP THE BASE UNIT (WALL MOUNTING)
MOUNTING ON A STANDARD WALL PLATE:
• Route the cords through the guides.
• Place the base unit on the posts of the wall plate and push down until it is
firmly seated.
NOTES:
• Do not use any outlet controlled by a wall switch.
• If you don’t have a standard wall plate, cut out the template on this page and
use it to position two screws (minimum length of 1
3
/
8
inches) into the wall
with the heads protruding about
1
/
4
inch.
INSTALLATION
Raise the antenna.
Telephone
Line Cord
Single-Line
Telephone Jack
(RJ11C)
Power Outlet
(AC 120 V, 60 Hz)
AC Adaptor
Preparation
Wall mount template
IMPORTANT:
Before mounting, select a wall area of sufficient
strength. If mounting on wallboard or in an area
of questionable strength, locate a stud for
maximum support of your telephone.
Avoid electrical cables, pipes, or other items
behind the mounting location that could cause a
hazard.
CUT
CUT
•
•
SX-2801.qxd 3/15/1 6:02 PM Page 11
