Toshiba Strata AirLink DK40i, Installation And Maintenance Manual

Page: 575 / 724

Peripheral Installation
PC/Data Communications Interface Units
Strata DK I&M 6/00
12-67
Pe
ri
p
h
er
a
l In
st
al
la
ti
on
Note
If using an RPCI-DI, it may be necessary to switch the RPCI from the TAPI mode to the
Data Communications Mode before proceeding with Step 3. To place the RPCI into the
data communications mode from the PC keyboard: Set
Num Lock
to On and type
240
while holding the
Alt
key down (this is HEX f0). If in the data communication mode,
ATC0 will switch the RPCI-DI back to the TAPI mode.
3. Using the manufacturer’s documentation, make sure the communication parameters (data
speed, parity, data bits, stop bits, etc.) of the PC COM port match the printer’s serial interface
parameters.
➤
To connect the PC to the printer
➤
Press
'DWD&DOO
+ on the DKT.
CONNECT on the PDIU-DS lights. The connection between the PC and the printer is completed,
as shown in
Figure 12-35 . (PDIU-DS 203 is in the communication mode).
Note
If busy tone is sent to the DKT, the connection is not complete; press
'DWD5HOHDVH
and
Step 3 again.
Operate the PC to print data as required.
Figure 12-35 DK PC to Printer Test Call Using Manual Dialing
➤
To terminate the call
➤
Press the DKT’s
'DWD5HOHDVH
button.
Internal PC-to-External PC Test using AT Commands
Note See Figure 12-36 for additional information.
1. Set the RPCI or DIU programming.
♦ Program 20: Port 000. LEDs 01, 02, 05, and 17 On; all other LEDs Off.
♦ Program 20: Port 004. LEDs 01, 02, 03, 04, 06, and 17 On; all other LEDs Off.
Digital
(Port 001)
TOSHIB
A
DIU
POWER READY CONNECT
TOSHIBA
MDF
MDF
RS-232
RS-232
Portable PC
DKT/PDIU-DI
(201)
Serial
Printer
PDIU-DS
(203)
Strata DK
Digital
(Port 003)
1537