Replacement Procedures
Satellite L830
Maintenance Manual (960-Q08)
22
Install the keyboard
The following describes the procedure for installing the keyboard.
1.
Turn the keyboard upside down and place it on the palm rest as its face down.
Connect the keyboard flexible cable to the connector on the system board.
2.
Make the keyboard a little convex deformation to insert the snap holder 13 ~ 14 into
corresponding slot toward the red arrow direction.(See Figure 4-7-4)
3.
Pressure the gap between the keycap “Y” and keycap “T” to insert the alignment boss
(on the rear side of KB) into slot of Top assembly. (See Figure 4-7-5 ~ Figure 4-7-7)
4.
Use both hands to keep step 2 and step 3 condition, push the keyboard toward the
green arrow direction. Make sure the snap holder 7 ~ 12 insert into corresponding slot
of Top assembly correctly. (See Figure 4-7-4)
5.
Pressure the snap holder 1 ~ 6 into corresponding clasp point. (See Figure 4-7-8)
Figure 4-7-5 Press snap holder
Snap holder 7 ~ 12 (from left to right) and corresponding slot
