User’s Manual
8-8
Optional Devices
6. Lift one side of the insulator sheet and fit the module's connectors into
the computer's connectors at about a 45 degree angle. Press the
module carefully to ensure a firm connection.
7. Push the module down so it lies flat. Latches on either side will click into
place to secure the module.
Installing the memory module
8. Seat the cover and secure it with the screws.
9. Replace the battery pack as described in Chapter 6,
.
10. Turn the power on and make sure the added memory is recognized.
Open
System
in the Control Panel and click the
General
tab.
Points to note about memory module error
If you install a memory module that is not compatible with the computer, the
Power indicator will flash (on for 0.5 seconds, off for 0.5 seconds) in the
following ways:
■
If there is only an error in Slot A: repeatedly flashes orange twice, then
blue.
■
If there is only an error in Slot B: repeatedly flashes orange, then blue
twice.
■
If there is an error in Slot A and in Slot B: repeatedly flashes orange
twice, then blue twice.
In all instances you should shut down the computer and remove the
incompatible module(s).
Do not touch the connectors on the memory module or on the computer.
Debris on the connectors may cause memory access problems.
Slot A is reserved for main memory. Use slot B for expanded memory. If
only one card is installed use slot A.
Slot B
Slot A
