6. Operation in Parameter Setup Mode
6-4
2
Select/confirm desire function using the control
dial.
Selected guidance window appears.
Functions of function keys
: Displays the previous window.
: Displays the next window.
Functions of function keys
: Displays the previous window.
: Displays the next window.
3
Change the parameter.
Operate the process 2 and 3 of “6.2 Setting a basic parameter”.
6.4 Setting an extended parameter (
f---
)
1
Select/confirm “Extended parameters” using
the control dial. When used with a VF-MB1
inverter, Select/confirm “Extended parameters
(
f---
)”
The Extended Parameters window appears.
Functions of function keys
: Displays parameters in the number range of
900.
The number displayed decrements each time
this key is pressed.
: Displays the previous window.
: Displays the next window.
: Displays parameters in the number range of
200.
The number displayed increments each time
this key is pressed.
2
Change the parameter setting.
To do this, perform steps 2 and 3 in the “6.2 Setting a basic parameter” section.
Parameter Setup Mode
Extended Parameters
F9--
F2--
F100 : Low-speed signal freq
F101 : Speed reach frequency
F102 : Speed reach freq band
F105 : Priority of FWD/REV
F106 : Input terminal priority
F1
F2
F3
F4
F1
F2
F3
F4
F2
F3
Guidance function
Preset speed
CMOd : Command input mode
FMOd : Frequency input mode 1
ACC :
Acceleration
time
1
dEC
: Deceleration time 1
FH :
Maximum
frequency
F2
F3
F2
F3
Basic Parameters
AUF
G
F2
F3
0: No function
1: No function
2: Preset speed
口
3: Analog signal operation
