Toshiba RDA-S 2001HA / D015-ME, Owner'S Manual

Page: 8 / 19

7
When you use the air conditioner for the first time or change the settings, follow the procedures below.
From the next time, pressing the ON/OFF button will run the air conditioner with the chosen settings.
●
Keep the breaker turned on during use.
●
When you resume using the air conditioner
after a long period of disuse, turn the power
switch on at least
12 hours before starting
operation.
Preparation
Correct Usage
When heating
●
The air conditioner may continue running in the FAN mode for about 30 seconds after stopping heating.
●
While preheating takes place the indoor fan will not move for 3-5 minutes. It will start working when the preheating
is finished. (The pre-heat indicator is displayed on the remote control)
●
The air volume becomes extremely low when the room temperature has reached the set temperature. However,
for floor types (direct type, duct type), the air volume does not change after room temperature has reached the set
temperature.
●
Running starts in approximately one minute.
When cooling
Turn on the circuit breaker and leakage breaker
●
When turned on, the separation line
appears and blinks on the
remote control display.
* The remote control will not work for
about one minute after turning on the
power. This is not a malfunction.
Note
Note
Operations
Changing the Temperature Setting
● Push to increase the temperature, and to
decrease the temperature. (The temperature setting cannot
be changed in the FAN mode.)
Push to select the temperature
Recommended temperatures
Heating: 22°C - 24°C
Cooling: 26°C - 28°C
Push the button
to select a running mode
Push the
button to start operation
1
● Each time you push the button, the running mode and its
indication change in the following order:
● The operation lamp lights up.
2
3
Push the button to stop
operation
● The operation lamp turns off.
Heating Cooling Fan