21
EN
Branch Kit 1:3
Procedure
5
1. Using temp. setup
/
buttons,
specify CODE No. [
14
].
(CODE No. [
14
]: Group address)
2. Using timer time
/
buttons,
change the setup data from [
0001
] to
[
0002
].
(Setup data [Header unit:
0001
]
[Follower unit:
0002
])
3. Push
button.
At this time, the setup finishes when the
display changes from flashing to lighting.
Procedure
6
If there is other indoor unit to be changed,
repeat procedure
2
to
5
to change the
setup. When the above setup has finished,
push
to select the indoor unit No.
before change of setup, specify CODE No.
[
12
], [
13
], [
14
] in order with temp. setup
/
buttons, and then check the
changed contents.
Address change check Before change:
[
3-3-1
]
→
After change: [
2-2-2
]
Pushing
button clears the contents of
which setup was changed.
Procedure
7
After check of the changed contents, push
button. (Setup is determined.) When
pushing
button, the display disappears
and the status becomes the usual stop
status. (When pushing
button the
operation from the remote controller is not
accepted for approx. 1 minute.)
* If the operation from the remote controller is not
accepted even 1 minute or more passed after
pushing
button, it is considered that the
address setup is incorrect.
In this case, the automatic address must be
again set up. Therefore repeat procedure of the
setup change from the Procedure
1
.
Indoor unit No. before setup change is displayed.
Indoor unit No. before setup change is displayed.
Indoor unit No. before setup change is displayed.
Summary of Contents for RBC-TRP100E
Page 25: ...EH99862001 a ...
