Wireless Remote Controller Kit
Owner’s Manual
– 13 –
11
HOW TO PERFORM EMERGENCY
OPERATION
In the event of an emergency shown below, push emergency operationeon the signal
receiving part (inside the ceiling panel or indoor unit) for emergency operation.
• The batteries of the remote controller have been exhausted.
• The remote controller is out of order.
• The remote controller has been lost.
1
Start
Push emergency operation.
(When the emergency operation is started at a room temperature of 24°C or more, the air
conditioner enters the cooling mode. When the emergency operation is started at a room
temperature below 24°C, the air conditioner enters the heating mode.)
2
Stop
Push emergency operation once again.
REQUIREMENT
The test run switch in the signal receiving part is used for a test run during the installation
work. Do not use it for other purposes.
1
2
13-EN
EH78981901_01EN_remo_OM.book Page 13 Saturday, November 10, 2007 4:26 PM
