Toshiba RAV-GM301ATP-E, Owner'S Manual

Page: 52 / 60

– 51 –
How to set up the louver direction
1
Push during operation.
The louver direction changes for every push of the
button.
In HEAT operation
Direct the louver (adjustment plate of up / down wind
direction) downward. If directing at horizontally, hot air
may not come to the foot.
In COOL / DRY operation
Direct the louver (adjustment plate of up / down wind
direction) horizontally. If directing it downward, the dew
may form on the surface of the air discharge port and
may drop down.
In FAN operation
Select a desired louver direction.
How to start swinging
1
Push , set the louver (adjustment plate
of up / down wind direction) direction to the
lowest position, and then push
again.
SWING is displayed and the up / down louver
direction is automatically selected.
Display during swinging
How to stop swinging
1
Push at a desired position while the
louver is swinging.
• When is pushed after that, wind
direction can be set again from the highest
position.
Display when swinging is stopped
In this case, push again two seconds later.
• In Cool / Dry operation, the louver does not stop
as it directs downward. If stopping the louver as
it directs downward during swing operation, it
stops after moving to the third position from the
highest position.
1
Unit select button
Initial setup
Initial setup
Initial setup
* However, even if is pushed while the
louver is swinging, the louver position is
displayed as follows and highest position of the
louver may not be selected.
Repeat
Fan / Heat
operation
Cool / Dry
operation
Display when stopping the swing
Unit select button
• When multiple indoor units are controlled with one
remote controller, louver direction can be set for
each indoor unit by selecting individually.
• To set louver direction individually, push
button to display an indoor unit number in the control
group. Then set the wind direction of the displayed
indoor unit.
• When no indoor unit number is displayed, all indoor
units in the control group can be controlled
simultaneously.
• Each time button is pushed, the display
changes as follows:
 How to set louver wind
direction individually
1
Select an indoor unit to be set by pushing
(left side of the button) during
operation.
• The indoor unit number changes each time you
push the button.
* When no unit number is displayed, all indoor units
are selected.
2
Select a louver you want to adjust change by
pushing
(right side of the button).
• Each time you push the button, the display on
the left of the remote controller changes as
follows:
* When no louver number is displayed, all four louvers
are selected.
3
Determine wind direction of the selected
louver by pushing
.
• Each time you push the button, the display
changes as follows:
* During COOL (DRY) mode, (4) and (5) are not
displayed.
Fan / Heat
operation
Cool / Dry
operation
Not
display
UNIT No.
1-1
UNIT No.
1-2
UNIT No.
1-3
UNIT No.
1-4
Not
display
Unit No.
1-1
Unit No.
1-2
Unit No.
1-3
Unit No.
1-4
Not
display
Louver No.
04 02
03
01
Drain pipe Refrigerant pipe
(1) (2) (3) (4)
(7) (6) (5)
101-EN 102-EN