40
Special points to consider
In case the remote control is misplaced, temporary Automatic operation is available from Temporary switch on the indoor unit.
If the remote control is not available
In the event 2 air conditioners are installed in close proximity
■
When operating
■
To stop
•
Fully Automatic operation. (Temperature and
air volume are set automatically).
•
Operation lamp turns on.
A - B Selection
To separate remote control usage for each indoor unit in case 2 air conditioners are installed adjacent to each other.
※
Indoor unit and remote control are set to A when shipped from the factory.
•
Automatic cleaning is not operated.
•
Operation lamp turns off.
B setting
How to set both the indoor unit and the remote control to B
•
Cooling or Heating starts after 10 seconds with a “Pi” sound. However, continue to press it.
Setting completes when the “Pi” sounds 5 times and the operation lamp blinks.
•
To cancel it, repeat the above operation (in this case, the operation lamp does not blink)
Start the operation smoothly and reduce the operating noise.
Concern about the operating noise
Press for 20 seconds
Quiet
When setting is complete.
Pi
P
i
Pi
P
i
Pi
1 second
1 second
again
1 second
20 seconds
1
Press Temporary switch for approx. 1 second to start automatic operation.
2
Point the remote control at the indoor unit.
3
Push and hold
CHECK
button on the Remote Control by the tip of the
pencil. “00” will be shown on the display. (Picture
1
)
4
Press
during pushing
CHECK
. “B” will show on the display and “00”
will disappear and the air conditioner will turn OFF. The Remote Control
B is memorized. (Picture
2
)
Note: 1. Repeat above step to reset Remote Control to be A.
2. Remote Control A has not “A” display.
3. Default setting of Remote Control from factory is A.
1
2
Summary of Contents for RAS-M10PKVPG-E
Page 43: ...1121450199 1 ...
