11
HiPOWER
START/STOP
PRESET
˚
C
AM
:
AUT
UTO
MODE
AUTO
FAN
ECO
TIMER
TIMER
Hi-POWER
SWING
MEMO
FIX
FILTER
RESET CLOCK CHECK
ON
OFF
SET
CLR
1
AM
HiPOWER
START/STOP
PRESET
ON
OFF
˚
C
:
AM
:
AUT
UTO
MODE
AUTO
FAN
ECO
TIMER
TIMER
Hi-POWER
SWING
MEMO
FIX
FILTER
RESET CLOCK CHECK
ON
OFF
SET
CLR
1
2
3
4
HiGH POWER OPERATION
High power (Hi POWER)
• The High power (High power operation) mode automatically controls
room temperature, operation mode so that the room is quickly cooled in
summer and warmed in winter. (Refer to page 15.)
Setting High power mode
1
Hi-POWER button
Push the Hi-POWER button.
The “Hi POWER” mark on the remote controller is indicated.
Canceling High power mode
1
Hi-POWER button
Push the Hi-POWER button once again. The “Hi POWER” mark on
the remote controller goes out.
CAUTION
The High POWER mode cannot be activated in the DRY and FAN
ONLY operation and when the ON TIMER operation is reserved.
TIMER OPERATION
ON timer and OFF timer
Setting TIMER
1
ON/OFF TIMER button
Push the ON or OFF TIMER buttons as required.
• The previous timer setting is displayed and flashes along with ON/
OFF TIMER display.
2
TIMER button
Push the TIMER button.
Set the timer to the desired time.
Each push of the TIMER button changes the time in ten minutes
steps. Pushing the TIMER button continually changes the time in one
hour steps.
3
SET
SET
button
Push the SET
SET
button to set the timer.
The timer time is indicated and the timer starts.
4
CLR
button
Push the CLR
button to cancel the timer setting.
CAUTION
• When you select the timer operation, the remote controller automatically transmits the timer signal to the
indoor unit at the specified time. Therefore, keep the remote controller in a location where it can trans-
mit the signal to the switch panel properly.
• If you do not push the SET
SET
button within 30 seconds after setting the time, the setting will be cancelled.
Once you select the timer operation mode, the settings are saved in the remote controller. Thereafter, the air
conditioner will start operating under the same conditions when you simply push the ON/OFF button of the
remote controller.
If the clock display is flashing, you cannot set the timer. Follow the instructions in the section “SETTING THE
CLOCK” on page 8 to set the clock, and then set the timer.
