No.
Part name
Procedures
Remarks
Cross flow fan
1) Follow the procudure item
⑧ and ⑩.
2) Loosen the set screw of the cross flow fan.
3) Remove 2 fixing screws from the bearing base
and 3 fixing screws of evaporator, then remove it
from the main unit.
4) Lift up the heat exchanger follow the figure.
Pull out the left hand side until the cross flow fan
released from the shalf of the fan motor and
thenpull out the lower side of heat exchanger
follow the figure.
<To re-installation>
1) To incorporate the fan motor and the motor into the
position in the following figure.
- Install the cross flow fan so that the right end if
the 1st joint from the right of the cross flow fan is
keep 5mm from closed wall of the main unit.
Bearing base
Hexagon screw driver
Screws
Screws of
evaporator
1
0
- 122 -