–
52
–
10-3. Indoor Unit
10-3-1. Installation Place
• A place which provides the spaces around the
indoor unit as shown in the diagram.
• A place where there are no obstacle near the air
inlet and outlet.
• A place which allows easy installation of the piping
to the outdoor unit.
• A place which allows the front panel to be opened.
• The indoor unit shall be installed as top of the indoor
unit comes to at least 2 m height. Also, it must be
avoided to put anything on the top of the indoor
unit.
CAUTION
• Direct sunlight on the indoor unit's wireless
receiver should be avoided.
• The microprocessor in the indoor unit should
not be too close to RF noise sources.
(For details, see the owner's manual.)
<Remote control>
10-3-2. Cutting a Hole and Mounting
Installation Plate
<Cutting a hole>
When install the refrigerant pipes from the rear.
1. After determining the pipe hole position on the
installation plate (
ð
) drill the pipe hole
(
∅
65 mm) at a slight downward slant to the
outdoor side.
NOTE :
• When drilling a wall that contains a metal lath,
wire lath or metal plate, be sure to use a pipe hole
brim ring sold separately.
<Mounting the installation plate>
Fig. 10-3-2
m from the right side edge is
e
center of pipe hole
35
120
180
240
23 mm
∅
65 mm
The center of the pipe hole is above
the arrow
.
Pipe hole
Fig. 10-3-1 Fig. 10-3-3
FILE NO. SVM-13003
5
4 °
45
°
5
7
°
(Top view)
Reception
range
Remote
control Remote
control
(Side view)
Indoor unit
I
ndoor unit
Recep
tion range
To unit out line
240mm
To unit out line
35mm
To unit out line
240mm
Of
fset 23mm from the r
ight side edge is
the center of pipe hole
To unit out line
120mm
0
23
35
120
180
240
Of
fset 85mm from the left side edge is
the center of pipe hole
170
170
5
0
4
0
85
132
23
∅
65
mm
Hook
Hook
Hook
Pipe hole
Pipe hole (
∅
65 mm)
Weight
Indoor unit
Thread
2
m
o
r
m
o
re
f
ro
m
f
lo
o
r
Anchor bolt holes
1
Installation plate
7
Mounting
screw
•
A place where there are no obstacles such as a
curtain that may block the signal from the remote
control.
•
Do not install the remote control in a place
exposed to direct sunlight or close to a heating
source such as a stove.
•
Keep the remote control at least 1 m apart from
the nearest TV set or stereo equipment. (This is
necessary to prevent image disturbances or noise
interference.)
•
The location of the remote control should be
determined as shown below.
Summary of Contents for RAS-22N3AV2-A
Page 109: ...TOSHIBA CARRIER THAILAND CO LTD ...
