No.
Part name
Procedures
Remarks
Fan motor
5
1) Follow the procedure item 3 and 4 .
2) Loosen the set screw of the cross flow fan.
3) Remove 2 fixing screws of the motor band.
4) Pull the motor band and the fan motor
outward.
3.5 mm
Cross flow fan
Set screw
Fan motor
Body back
Horizontal louver
6
1) Remove shaft of the horizontal louver
from the back body. (First remove 2 the
center shafts then remove the other shafts.)
<To re-installation>
- Keep connector position and arrange fan
motor wire follow figure.
Hexagon screw driver
Vertical louver
Cross flow fan
Screws
Fan motor
Motor band
(45°)
Fan motor
connector
Fan motor wire
Horizontal louver
Drain pan
Drain pan
Drain hose
1) Follow the procedure item 3 .
2) The drain hose can be removed by removing
the screw securing the drain hose and then
pulling out the drain hose.
3) When removing the drain hose, be careful of
any sharp edges of steel plate. The edges can
injuries.
<To re-installation>
- To install the drain hose, insert the drain hose
firmly until the connection part contacts with
heat insulator, and then secure it with original
screw.
Screw
Drain hose
Drain pan
Steel plate
of drain hose
Heat insulator
of drain pan
Drain hose
7
- 117 -
