Toshiba Portege 2000, Maintenance Manual

Page: 214 / 270

4 Replacement Procedures 4.15 Fluorescent Lamp
4-62 Portage 2000 Maintenance Manual (960-333)
10. Screwing the PCB and the bezel
1) Use two screws to secure the left and right edge in the order of
①
.
Caution: 1) The screw tightening torque is 0.167N·m(1.7kgf·cm) for all screws.
2) Use a Philips screwdriver with type 0 bit.
11. Installing the tapes and insulation sheets
1) Stick the double-faced tape of the insulation sheet 1and 2 in the drawing below
②
2) Stick the bezel tape 1 to the bottom edge of the lamp side in the drawing below
③
.
3) Stick the bezel tape 2 to the.
4) Stick the bezel tape 2 to the insulation tape 1and 2 in the drawing below
⑤
Caution: 1) Refer to the drawing below.
2) When the tapes and insulation sheets are installed, be careful not to
damage the cell and B/L.
Bezel tape 2:Stick insulation tape 1&2 to the I/F connector side.
Production sheet
Bezel tape 2: Bezel tape 2:
Between scribing
lines
Between scribing
lines
Between scribing lines
Let not it out of the
ceiling of bezel.
Between scribing lines
to the edge of frame of the back
Let not it stuck to the reflection sheet.
Width of frame
Width of frame
to the center of frame surface of the back
Insulation sheet
under the I/F
connector
Bezel tape 1:
to the scribing line from the bezel side
let not it out of the ceiling of bezel.
Let not it stuck to the reflection sheet.
Stick double-adhesive
insulation sheet 1&2 to
the frame corner.
Figure 4-51 Replacing Toshiba fluorescent lamp(11)