8
NetPac Wireless System
Hardware Installation and
Connections
C o n t a c t W i t h E n e r g i z e d W i r i n g
W i l l C a u s e S e v e r e I n j u r y O r
L o s s O f L i f e .
There are two types of transceiver modules used with the
7-Series ASD. The
Series-2
(shown below) is used with the
7-Series ASD only and the RJ-45 type (shown on
) is used
with the 7- and 9-Series ASD.
Series-2 Transceiver Module
Installation
1. Ensure that all system/ASD power is off and that the ASD
Power
and
Charge
LEDs are off.
2. Open the front door or remove the front cover (device-
specific) of the ASD to gain access to the control board of
the ASD.
3. Remove the factory-installed
Jumper PCB
from the
J4
connector of the control board
(note Jumper PCB orientation in
the event that a re-installation is
required) — the
Jumper PCB
is
no longer required.
4. Insert the
Adapter Board
(P/N 59513) into the
J4
and
J5
dual
in-line rows of connectors of
the control board (figure to right)
— ensure that the board is inserted with the correct
DANGER
