NetPac Wireless System
9
orientation and that all mating pins are seated fully and
uniformly.
5. Insert the
Series-2 Module
(P/N 64709) into the
Adapter Board
— ensure that the
module is inserted with the correct orientation and that all
mating pins are seated fully and uniformly.
6. Close the front door or reattach the front cover (device-
specific).
7. Apply system/ASD power.
Note:
CNU1
of the control board
CANNOT
be used
while using the
Toshiba NetPac Wireless System
.
RJ-45 Transceiver Installation
1. Perform steps
the
2. Insert the transceiver
module into the RJ-45
connector of the 7-Series (CNU1) or 9-Series (S4) ASD
terminal board.
PC USB Transceiver Installation
1. Insert the
USB
Transceiver Module
into any unused USB
port of the PC.
Once the module is
properly inserted into
the USB port of the PC, the
Found New Hardware Wizard
dialog box appears.
of the
