NetPac Wireless System
17
System Operation
The
USB Transceiver Module
of the
Toshiba NetPac
Wireless System
must be inserted into the same USB port to
which it was installed for proper operation.
For additional information, see the section titled
Transceiver Installation” on page 9
.
ASD Setup Requirements
The
ASD Transceiver Module
of the ASD may be flashed
with the programming of a
Coordinator
or a
Router
. The
ASD system setup requirements are identical for both types.
•
Set parameter
F003
to
RS232/RS485
.
•
Set parameter
F004
to
RS232/RS485
.
•
Set parameter
F851
to provide a system disposition in the
event of a communications loss.
2-Wire and 4-Wire Operation
The
7-
and
9-Series ASD NetPac Wireless Systems
may be set
for
2-Wire
or
4-Wire
operation.
The ASD must be set to the 2- or 4-wire configuration as
indicated on the transceiver module being used (see the module
part numbering convention on
).
For the
7-Series
ASD, place jumpers at the
JP1
and
JP2
terminals of the control board
(P/N 56000) as shown for half-duplex (2-
wire) operation.
Remove all jumpers for full-duplex(4-wire)
operation.
For the
9-Series
ASD, place both switches of
SW200
of the terminal board in the On
position for half-duplex (2-wire) operation.
Place both switches in the Off position for 4-wire operation.
JP1
JP2
FULL
HALF
