Toshiba E-Studio 5506AC, Paper Preparation Manual

Page: 37 / 46

2.PLACING ORIGINALS
Placing Originals 37
PLACING O
R
IGINALS

Scanning originals with the ADF at copying
Place originals at the ADF.
1 Align all the originals.
Collate the originals in the order that you want them to be copied. The top sheet of the originals will be copied
first.
2 Place the originals with their face up and align the side guides to the original length.

When using the DSDF, originals are acceptable up to 300 sheets (35 to 80 g/m
2
(9.3 to 20 lb.)) or 38 mm (1.50")
in height, regardless of their sizes.

When using the DSDF, passages of a large number of originals with curled wavily may cause paper misfeeding.
In that case, reduce the number of the originals.

For mixed-size originals, see the following page:

P.39 “Scanning mixed-size originals in one operation”
When using the DSDF, the paper feeding tray will automatically move upwards in ten seconds after placing
originals. The time until the tray moves upwards can be changed. For details, contact your service representative.
3
Set each mode in Copy/Scan/Fax and press the [START] button, the originals are scanned.

In Scan and Fax, you can view your scans with the preview feature on the screen. For operations of the preview
feature, refer to the Scanning Guide and Fax Guide.

In Copy, the feed mode can be changed when the originals are scanned.

P.38 “Continuous feed mode (copy)”

P.38 “Single feed mode(copy)”
When there are too many originals to be scanned at one time, divide the originals into several sets before copying.
Place the first set of the originals and then press [Continue] on the touch panel while the data of this set are being
scanned. When this scanning is finished, place the next set of the originals and press the [START] button on the control
panel. (If you press [Continue], this button may not work shortly before scanning is finished.)