14
Start up
Changing the program mid-cycle
1. The plug shall be firstly plugged into the socket. Power supply shall be of
220-240V AC 50Hz type, with socket of 10 A 220-240V AC.
2. Make sure that the water supply is turned on to full pressure.
3. Close the door, press "ON/OFF" button turn on the dishwasher.
4. Press the button of desired program, the corresponding indicator will light up.
5. Then, pass”Start/Pause”button to start.
A wash cycle can only be changed if it has been running for a short time otherwise, the
detergent may have already been released and the dishwasher may have already drained
the wash water. If this is the case, the dishwasher needs to be reset and the detergent
dispenser must be refilled. To reset the dishwasher, follow the instructions below:
1.
Press the Start/Pause button to pause the washing.
2.
Press the Program button for more than 3 seconds, the dishwasher will enter
standby mode.
3.
Press the Program button to select the desired program.
4.
Press the Start/Pause button, the dishwasher will run after 10 seconds.
3 seconds
