The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which would
have a detrimental or adverse effect on the operation of the appliance.
The more minerals there are, the harder your water is.
The softener should be adjusted according to the hardness of the water in your area. Your
local Water Authority can advise you on the hardness of the water in your area.
Use the dishwasher
Water softener
16
0 - 5
6 - 11
12 - 17
18 - 22
23 - 34
35 - 45
dH
dH
0 - 0.9
1.0 - 2.0
2.1 - 3.0
3.1 - 4.0
4.1 - 6.1
6.2 - 8.0
Mmol/l
Mmol/l
Digital display stalls
WATER HARDNESS
H1
H2
H3
H4
H5
H6
Setting on the
water softener
1
2
3
4
5
6
1)
2)
*
1) German degree of measurement for the water hardness
2) millimol, international unit for water hardness
* The manufactory setting: H4
The dishwasher is designed to allow for adjustment in the amount of salt consumed
based on the hardness of the water used. This is intended to optimise and customise the
level of salt consumption.
Please follow the steps below for adjustment in salt consumption.
1.
Close the door and s
witch on the appliance
2. Press the Start/Pause button for more than 5 seconds
,
when the salt indicator
flashes means entering
the water softener
settings.
set model within 60 seconds after the appliance was switched on
.
3. Press the Start/Pause button to select the proper set according to your local
environment, the sets will change in the following sequence:
H1->H2->H3->H4->H5->H6
.
4.
Without any operation in five seconds, the machine will exit from set mode, the
machine is into standby status.
.
Adjusting salt consumption
