Direct Access Parameter Information
https://www.toshiba.com/tic/
247
Monitor Output Function Command 41
Program
My Function
My Function Monitor
This parameter plays a role in the setup of the My Function fea
-
ture by allowing the user to select the Maximum, Minimum, or
Normal (Avg.) value of the parameter
selection to be
recorded and output as a monitored function.
Settings:
0 — Normal
1 — Maximum
2 — Minimum
See the My Function Instruction Manual (P/N E6581335) for a
complete description of the setup requirements and operational
information of the Monitor Output Function parameter.
Direct Access Number —
F972
Parameter Type —
Selection List
Factory Default —
Normal
Changeable During Run —
Yes
Virtual Input Terminal Selection 1
Program
Terminal
Input Terminals
This parameter is used to set the functionality of the Virtual Input
Terminal 1. As a virtual terminal, it exists only in memory and is
considered always to be in its True (connected to CC) state.
It is often practical to assign a function to this terminal that the
user desires to be maintained regardless of external conditions or
operations.
This parameter sets the programmable Virtual Input Terminal 1
terminal to one of the functions that are listed in
.
In addition, the input terminal must be specified as Normally
Open or Normally Closed.
Direct Access Number —
F973
Parameter Type —
Selection List
Factory Default —
Unassigned
Changeable During Run —
No
Virtual Input Terminal Selection 2
Program
Terminal
Input Terminals
This parameter is used to set the functionality of the Virtual Input
Terminal 2. As a virtual terminal, it exists only in memory and is
considered always to be in its True (connected to CC) state.
It is often practical to assign a function to this terminal that the
user desires to be maintained regardless of external conditions or
operations.
This parameter sets the programmable Virtual Input Terminal 2
terminal to one of the functions that are listed in
.
In addition, the input terminal must be specified as Normally
Open or Normally Closed.
Direct Access Number —
F974
Parameter Type —
Selection List
Factory Default —
Unassigned
Changeable During Run —
No
Summary of Contents for DN-68249-003
