Toshiba Carrier RBC-AMS41UL, Owner'S Manual

Page: 10 / 26

Remote controller with weekly timer
Owner’s Manual
– 10 –
Changing the air speed
1
Push the button (33), and select
the desired air speed.
• Each time the button is pushed, the air
speed display changes in the sequence
shown below.
• Stop pushing the button when the symbol
corresponding to the desired air speed
lights.
* If, during heating, the rooms do not heat
up quickly at the low air speed setting,
change the setting to high or medium.
* The auto air speed cannot be selected
during fan operations.
Changing the temperature
1
Push the TEMP. and buttons
(49), and select the desired
temperature setting.
• When the button (49) is pushed, the
temperature on the numeric display goes
down; conversely, when the
button
(49) is pushed, the temperature displayed
goes up.
• The temperature cannot be set during fan
operations.
„
Adjusting the air direction
The functions will differ depending on the
model and system.
• To increase the cooling or heating effect,
be sure to change the louver direction
between cooling and heating operations.
• The nature of air is to fall toward the floor
where it collects when it is cold and to rise
toward the ceiling where it collects when it
is warm.
CAUTION
• For cooling operations, set the
louvers to the horizontal blow-out
position.
Performing cooling operations with the
louvers at the downward blow-out
position may cause condensation to
form around the air outlets and louver
surfaces and water may drip.
* For further details, refer to the
operating instructions of the air
conditioner.
Changing the air direction
1
During operation, push the
button (39), and select the desired air
direction.
• Each time the button is pushed, the air
direction display changes in the sequence
shown below.
• Stop pushing the button when the symbol
corresponding to the desired air direction
lights.
* Air directions 4 and 5 are not displayed
during cooling or dry operations.
* It may not be possible to set air direction
1 after the air direction has been at the
random setting.
If this is the case, wait 2 seconds, and
then push the button (39) again.
Starting the louver swing motion
1
During operation,
push the
button
(39), and select the
symbol shown on the
right.
• If the button is then pushed from the
downward blow-out position, the symbol
shown on the right lights for the air direction
display.
Auto air speed High air speed
Low air speed Medium air speed
1 2 3 4 5
Random SWING
9-EN
+00EH99677901_01EN_OM_Remo_Weekly_UL.book Page 10 Thursday, October 8, 2009 2:03 PM