EN
– 12 –
6
Push the
button to finish the setting.
* F1 appears in the CODE No. section on the
remote control. This indicates that the louver 01
is selected.
NOTE
Even in louver lock mode, the louver temporarily moves
in the following cases:
• When the air conditioner stops
• When heating starts
• When defrosting
• When the thermostat is off.
◆
Releasing the louver lock
Set “0000” in Step 4 of “Setting the louver lock”.
The
mark disappears.
* Steps 1 - 3 and 5, 6 of
“Setting the louver lock” also
apply to releasing the lock.
◆
Adjusting the horizontal direction
1
Push and hold the
and “TEMP.
”
buttons for at least 4 seconds while running
is stopped.
blinks.
“01” appears in CODE No.
2
Push the
button (left side of the button)
to select a unit
The unit number changes each time the button is
pushed.
The fan of the selected unit runs, and the louver
swings.
3
Push the “TEMP.
” buttons to
change the CODE No. to “45”.
4
Push the “TIME
”buttons to select a
direction.
5
Push the
button to check the settings.
The indicator stops blinking and stays lit, and the
settings are confirmed.
6
Push
button to finish the setting.
* If the cold draft position is selected, the ceiling
smudging reduction effect will be reduced.
0001 - 0005
(Louver position
code)
Louver No.
0000
SET DATA
Direction SET
DATA
Direction setting
“0000”
Smudging reduction position
(reduces ceiling smudging)
“0002”
Cold draft preventive position
(Prevent cold draft)
[Factory default]
UNIT LOUVER
Unit No.
1-1
Unit No.
1-2
Unit No.
1-3
Unit No.
1-4
No display
4-way Cassette type
• The louver automatically closes when the unit stops
running.
• In the pre-heating mode, the louver points upward.
The swing indication appears on the remote control
even in pre-heating mode, however the actual swing
starts only after pre-heating is complete.
▼
2-way and 3-way air discharge
The air discharge can be changed to the 2-way or 3-
way type to suit the room shape and style.
For details, contact the dealer where you purchased
the air conditioner.
Ceiling type
Vertical adjustment
• The louver automatically points upward when the
unit stops running.
• In pre-heating mode, the louver points upward.
The swing indication appears on the remote control
even in pre-heating mode, however the actual swing
starts only after pre-heating is complete.
Horizontal adjustment
◆
Unit select
• When two or more indoor units are controlled with
one remote control, the louver direction can be set
for each indoor unit by selecting them individually.
• To set the louver direction individually, push the
button (left side of the button) to display an
indoor unit number in the control group. Then set the
louver direction of the displayed indoor unit.
• When no indoor unit number appears, all indoor units
in the control group can be controlled
simultaneously.
• Each time the
(left side of the button) is
pushed, the indication changes as follows:
▼
When cooling
Point the louver horizontally.
▼
When heating
Point the louver downward.
▼
When cooling
Point the louver horizontally to send cool air across the
entire room.
▼
When heating
Point the louver downward to send heated air to the
floor.
When adjusting the louver direction horizontally, point
the vertical grille inside the horizontal louver in the
preferred direction.
UNIT LOUVER
UNIT LOUVER
Unit No.
1-4
No
display
Unit No.
1-1
Unit No.
1-2
Unit No.
1-3
23-EN
24-EN
