15
D4222901B
Copyright © 2013 TOSHIBA TELI CORPORATION, All rights reserved.
www.toshiba-teli.co.jp
6.4
Random Trigger Shutter specification
Trigger Mode
External trigger, Software trigger (factory setting : External trigger)
External trigger
Input via I/O connector
Input circuit
Input level
Low: 0 to 0.5V, High: 2.0 to 24.0V
Polarity
High active / Low active (factory setting : Low active)
Pulse width
50
µ
s (minimum)
Input impedance
High impedance
Software trigger
USB3 Vision command control
Exposure time
Edge mode, Level mode (factory setting : Edge mode)
Edge mode
The exposure time depends on the MANUAL Exposure time setting
Level mode
The exposure time depends on External trigger width
Bulk mode
The exposure time depends on the MANUAL Exposure time setting
Max number of Exposures in Bulk mode
255 times
Trigger Delay
0 to 4095
µ
s (factory setting : 0
µ
s)
6.5
GPIO Output signal specification
Output channel
2 channels
Output signal
TIMER0 ACTIVE, USER OUTPUT, EXPOSURE ACTIVE,
FRAME ACTIVE, FRAME TRANSFER, FRAME TRIGGER WAIT
Output level
5V CMOS
Polarity
High active / Low active (factory setting : Low active)
Timer0 Active
Delay
0 to 4095
µ
s (factory setting : 0
µ
s)
Duration
0 to 4095
µ
s (factory setting : 0
µ
s)
TimerTriggerSource
Line0Active, ExposureStart, FrameTrigger
6.6
Interface specification
Interface
USB 3.0 (Only SuperSpeed is supported)
Transmission speed
5Gbps (Maximum)
Protocol
USB3 Vision
Cable length
Up to 3.0 m