2. PRINTER SETUP
ENGLISH VERSION EO1-33059
2.9 Setting an Operating Environment
E2-21
2.9.1 Parameter Setting
(Cont.)
When ON is selected, pressing the
[PAUSE]
key will result that the LCD
Message Display shows the stop position fine adjustment value setting
screen.
[FEED]
key:
Pressing the
[FEED]
key one time causes a –0.5mm change,
up to –5.0 mm.
[RESTART]
key: Pressing the
[RESTART]
key one time causes a +0.5mm
change, up to +5.0 mm.
After selecting an auto forward wait, press the
[PAUSE]
key.
(10) Head Up Cut/Rewinder Selection
This parameter is to choose whether to activate the head up action in the
cut issue or to use the Rewinder in the batch or strip issue.
This function prevents ribbon smudges by raising the print head during a
reverse feed to the print start position.
When “<2>PARAMETER SET” appears, press the
[PAUSE]
key until
the following display appears.
Use the
[
FEED]
or
[RESTART]
key to select a desired option.
After selecting the head up action in cut issue or use of the Rewinder,
press the
[PAUSE]
key.
POSITION +5.0mm
POSITION +0.0mm
[RESTART]
[FEED]
POSITION -5.0mm
<2>PARAMETER SET
POSITION +0.0mm
<2>PARAMETER SET
HU CUT/RWD OFF
[RESTART]
[FEED]
HU CUT/RWD OFF
Head up cut is not activated or the Rewinder
is not used.
HU CUT/RWD ON
Head up cut is activated or the Rewinder
is used.
NOTE:
The print head may not be raised
depending on the rise of the
solenoid’s temperature.
Summary of Contents for B-SX5T Series
Page 3: ...TEC Thermal Printer B SX5T SERIES Owner s Manual ...
Page 120: ...M EO1 33059 ...