65/5560 PRECAUTIONS
1
MAY.1997 © TOSHIBA CORP.
GENERAL PRECAUTIONS REGARDING THE INSTALLATION AND
THE SERVICE OF THE 6560
1.
Transportation/Installation
•
When transporting the copier, move it by the casters while lifting the stoppers.
The copier is quite heavy and weighs approximately 230 kg (507 lb); therefore, pay full attention
when handling it.
2.
Installation
•
Be sure to use a dedicated outlet with AC 115V/15A (220V, 230V, 240V/10A) or more for the
power source.
•
The copier must be grounded for safety.
Never ground it to a gas pipe or a water pipe.
•
Select a suitable place for installation.
Avoid excessive heat, high humidity, dust, vibration and direct sunlight.
Also provide proper ventilation as the copier emits a slight amount of ozone.
•
To insure adequate working space for copying operations, keep a minimum clearance of 80 cm
(32") on the left, 80 cm (32") on the right and 10 cm (4") in the rear.
3.
Service of Machines
•
Basically, be sure to turn the main switch off and unplug the power cord during service.
•
Be sure not to touch high temperature sections such as the exposure lamp, the fuser unit, the
damp heater and their periphery.
•
Be sure not to touch high-voltages sections such as the chargers and the high-voltage transformer.
•
Be sure not to touch rotating/operating sections such as gears, belts, pulleys,etc.
•
When servicing the machines with the main switch turned on, be sure not to touch live sections
such as the lamp terminal etc.
•
Use suitable measuring instruments and tools.
